I was honestly surprised by the quality and they look really good. Installation was pretty easy, I’d suggest using clamps or 2 people just to make your life easier
I had a set of heavy rubber flaps 12X18 sitting around the shop and these brackets did the trick, I'm used to bolting flaps to a piece of angle iron bolted to the truck frame pretty simple right? I still don't understand the why with all the parts and with the oddly placed holes and the slotted piece that goes inside the fender on the tire side, It seems kinda complicated but I'm not an engineer, all in all, pretty solid set up once I figured it out, the instructions recommended a specific video on utube but it said this video has been removed, I found one that was ford branded and it worked along with the instructions.
Ordered the front set of 12" X 26" Flaps and Brackets for my 2020 Super Duty. The installation took very little time compared to the rear. Overall, everything turned out well in the end. I did paint the brackets black so as to not have them stand out so brightly against the black flaps. Time will tell on the durability of the flaps and brackets.
Ordered the rear set of 12" X 26" flaps and Brackets for my 2020 Super Duty. The installation took longer than expected due to having to use the template and drill holes, cut slots, etc. My truck also did not have the factory rear wheel well liners and I had purchased some from a different vendor. I installed everything at the same time so drilling holes to line up the liner and the brackets took quite a bit of planning. Overall, everything turned out well in the end. I did paint the brackets black so as to not have them stand out so brightly against the black flaps. Time will tell on the durability of the flaps and brackets.