Truck Hardware Gatorback Mud Flaps

Very easy to install and they look great on my 2022 GMC.

These fit great ….. easy install look amazing and no need to modify rock rails

These things absolutely kick ass! With putting bigger tires on my truck, I had to remove the stock front mudguards and didn’t know what to do with the eye sore of the missing flap. I stumbled across these finishing caps, and knew that was the answer, and I’m so glad I found them! I installed them, and they look absolutely amazing! Thank you so much Sharp Truck! Top notch company, and even put in a had written thank you note, thanking me for my business. You guys will be my go to place for my truck needs!

These mud flaps were easily installed, and feel they are great quality. I have no doubt they will outlast the truck!  

First - these are a bit on the expensive side for "mud flaps", but whoever fabricated the means to attach them did a good job of doing this. Kudos to him! The "video" showing the installation of these on a Ford truck was very helpful. The only issue I had on installing the front flaps were the "spacer" listed as rubber in the instructions was nylon (Approx. 1/4 inch thick). I had to grind off the spacer shown in Photo#1 so it would fit flush to the backside of the body on the front bolt. There was a lip that prevented it from sitting flush to the body. (Photo #2) One of the things I do not like is the location of the "insert area", bottom backside of the flap, where a person can attach a "logo" - Ford - Dodge- etc. This prevents the flap from being more flexible, ex. if you do any off-roading and just drop off a small rock ledge or rock this prevent it from flexing if it was thinner in this area of the flap. Overall though they work well. A person would have to pay attention to when backing up that you don't pinch the flap between a rock and the tire. This would rip the flap off, as I have done in the past, with flaps I have fabricated for other vehicles I have put on. One of the rear flaps installation components (r) (strip nut) is a little to flimsy. Just don't over tighten screws to this and the "cap bolts" that attach the flaps using the (q) "spring nut". I ended up using "nyloc" nuts.

Great accessory for my new RAM 2500

Just what I needed. They work perfectly and the pictures are proof positive.  1/2 mile of dirt road muddy and snow packed on first photos same road one day later after install and going to town to wash the bronco the road was muddier on the return trip and the gatorbacks did the job!

Just what I needed. They work perfectly and the pictures are proof positive.  1/2 mile of dirt road muddy and snow packed on first photos same road one day later after install and going to town to wash the bronco the road was muddier on the return trip and the gatorbacks did the job!

Fits perfect just what i wanted.

If you are getting these to protect your trailer don't do it. They are more for appearance and keeping mud out of your bumper. They install nicely. Use extra fasteners! I would suggest removing the tires for install.