The Truck Hardware Gatorback Black Wrap Bronco Mud Flaps rear pair combines serious protection with a "Bronco" text logo on a black wrap 304 stainless steel plate for 2021-2027 Ford Bronco models (excluding Bronco Raptor). Gatorback is a premium mud flap built to a higher standard than typical aftermarket flaps, and it shows the moment you pick one up. Each flap is cut from heavy-duty, 1/2" thick premium rubber and mounted on a durable nylon upper bracket with a 1.5" kickback for extra tire clearance, and a sliding channel lets you remove the rubber when you need it. The result is a flap built for the trail that keeps doing its job for the life of your Bronco.
These 12.5" wide flaps protect your Bronco from rocks, mud, gravel, snow, slush and road debris, so you will see your Bronco staying cleaner longer, less mess on your rocker panels and doors, and fewer rock chips in the paint. The Bronco logo plate gives your Bronco a distinctive, bold appearance that is ready for any trail. Gatorback flaps are some of the highest quality, heaviest duty mud guards in the industry, and they are proudly made in Canada. If you are looking for mud flaps you buy once and never think about again, this is them.
Key Features
- Heavy-duty 1/2" thick virgin rubber - Many aftermarket flaps use thinner, recycled rubber that can curl, sag or tear over time. Gatorbacks use thick, premium virgin rubber that resists cracking and stays strong and flexible through heat, cold, rocks and gravel.
- Black wrap "Bronco" logo plates - A "Bronco" text logo on a 304 stainless steel plate with a black wrap overlay for a bold, rugged look that resists rust and corrosion.
- 1.5" offset nylon kickback bracket - The durable nylon upper bracket (1.5" kickback) adds tire clearance and resists fading, chipping and cracking, and a sliding channel lets you remove the rubber when needed.
- Lifetime rubber warranty - The rubber is covered for life against tears or damage under normal use, and the nylon brackets carry a 1-year warranty against manufacturing defects.
Which Gatorback Is Right for Your Vehicle?
Gatorback mud flaps for the 2021-2027 Ford Bronco come in several versions. Use this quick guide to make sure you pick the right one:
- Front, rear, or set of 4 - This listing is the rear pair only (2 flaps), which fits all non-Raptor Broncos. Add a front pair that matches your Bronco (with or without rock rails), or choose a set of 4.
- Rock rails vs. no rock rails - The front flaps come in two versions: one for Broncos WITH rock rails, and one for Broncos without rock rails (compatible with removable hoop steps). The rear flaps are the same for both.
- Bronco Raptor and tire size - These flaps do NOT fit the Bronco Raptor. They fit tires up to 35"; 30" tires are not recommended.
- Choosing a style - This version is the black wrap Bronco text logo style. It is also available in: black anodized Bucking Bronco logo, black wrap Bucking Bronco logo, black American flag, black anodized aluminum plate, American flag and plain rubber (no plate).
Features and Benefits
These flaps are made from premium, heavy-duty virgin rubber, known for its durability and flexibility. It resists cracking and damage even under extreme conditions, so your Bronco stays protected on the trail and on the road. The 12.5" wide flaps provide 10.5" of rear tire coverage, measured from the bottom of the fender to the bottom of the flap, protecting your Bronco and the vehicles behind you from debris.
An exclusive black wrap "Bronco" text logo is embossed into a removable 304 stainless steel plate, giving your Bronco a distinctive, rugged look with excellent corrosion resistance. You will appreciate the attention to detail in these flaps.
Fit is built in. These flaps are designed specifically for 2021-2027 Ford Bronco models, including Base, Big Bend, Outer Banks, Badlands, Heritage Edition and Stroppe Edition trims, and they do not fit the Bronco Raptor. The durable nylon upper brackets use a 1.5" kickback for added tire clearance and are engineered to resist fading, chipping and cracking. They mount on black anodized aluminum brackets with black oxide stainless steel fasteners, and a sliding channel lets you remove the rubber lower section when needed. The flaps fit tires up to 35" (30" tires are not recommended). Gatorback mud flaps are an officially licensed Ford product, proudly made in Canada. The rear flaps install flush to the inside of the wheel well, so they work with step bars, power boards or side steps.
Installation
Installation is hassle-free, with no body drilling required. The flaps align with your Bronco's factory mounting points, and the custom fit brackets and all necessary hardware are included. Each flap takes approximately 15 minutes to install with basic hand tools you already have at home. Install videos and installation instructions are available so you can see the full process step by step before you start.
What's Included
- (2) Gatorback Black Wrap Bronco 12.5" wide rear mud flaps (1 driver side, 1 passenger side)
- Custom fit mounting brackets
- All necessary hardware for installation
Care & Maintenance
- Clean the rubber regularly with a mild soap and water solution to remove dirt, mud and grime. Regular cleaning helps keep the rubber flexible and extends the life of the flaps.
- Avoid harsh chemicals and petroleum-based cleaners, which can degrade rubber over time.
- Rinse thoroughly and let the flaps air dry for best results.
- Wipe down the nylon brackets with a damp cloth and a mild pH-balanced soap to keep them in top condition.
- Clean the black wrap plates with a soft cloth and a stainless steel cleaner, or a mild soap and water solution, to maintain their polished appearance. For tougher stains or minor surface corrosion, use a stainless steel cleaner made for automotive use. Avoid abrasive materials that could scratch the surface or damage the finish, and dry the plates thoroughly to prevent water spots.
- Check the mounting hardware periodically and retighten if needed, especially after off-road or rough-road driving.
Warranty
Gatorback mud flaps are backed by a limited lifetime warranty on the rubber portion of the flap, covering tears or damage under normal use for the lifetime of the product to the original owner. If a flap comes off or is damaged due to normal wear and tear, let us know and we will send you a replacement piece of rubber at no charge. The nylon brackets include a one-year limited warranty against manufacturing defects.
Plates and mounting hardware are not covered by the warranty. The warranty also does not cover damage caused by misuse or abuse. To start a warranty claim, please provide product photos and proof of purchase.
Terms to Know
- Virgin rubber - Rubber that has not been recycled or reprocessed, offering better consistency, durability, flexibility and resistance to cracking than reclaimed rubber.
- No-drill installation - Mounting that uses your vehicle's factory mounting points, so no holes are drilled and the original body and finish are preserved.
- Tire coverage - How far the flap extends below the fender, blocking road spray and debris (10.5" rear on this rear pair).
- Kickback bracket - A bracket that provides additional clearance between the mud flap and the tire (1.5" here), allowing better fitment without interference.
- Rock rails vs. hoop steps - Rock rails are rigid side protection rails along the rocker panels; hoop steps are removable step loops. Bronco front flaps are made for one or the other.
- 304 stainless steel - A premium grade of stainless steel known for excellent rust and corrosion resistance, ensuring a durable, long-lasting finish.
- Black wrap - A black vinyl finish applied over the stainless steel plate for a sleek, darkened look.
Specs at a Glance
- Brand: Truck Hardware Gatorback
- Part Number: GCN406R-BRW
- Position: Rear pair (driver and passenger)
- Fitment: 2021-2027 Ford Bronco
- Trims: Base, Big Bend, Outer Banks, Badlands, Heritage Edition and Stroppe Edition
- Does Not Fit: Bronco Raptor
- Style: Black wrap "Bronco" text logo on 304 stainless steel plates
- Plate: Black wrap 304 stainless steel (removable)
- Brackets: Nylon upper with 1.5" kickback, black anodized aluminum brackets
- Hardware: Black oxide stainless steel fasteners
- Flap Width: 12.5"
- Rubber: 1/2" thick heavy-duty virgin rubber
- Tire Coverage: Rear 10.5" from fender to bottom of flap
- Tire Size: Up to 35" (30" not recommended)
- Installation: No body drilling, about 15 minutes per flap
- Made In: Canada
- Warranty: Limited lifetime on the rubber; 1-year limited on nylon brackets; plates and hardware not covered