Keep the inside of your car or truck looking as good as the day you drove it off the lot with the added protection of seat covers. These easy to follow installation steps will give you a general idea of just how easy it is to add seat protection to your vehicle. Next time you spill your coffee in the morning or drop your burger at lunch, you'll be glad that you had this extra layer of protection on the interior or you ride.

There are usually two different styles of seat covers available, one for bucket seats and one for bench seats. Before you order yours, its always good to have an idea of how the product installs and how it protects your seats. A variety of different materials are available to match the look and feel of your vehicle, so pick one out that suits you best. The installation guide below will give you the general steps needed to add seat covers to your car or truck.

Bucket Seats

1. Remove your headrests
2. Slide the seat cover over the back of your seat, making sure that the cover's seams match up with your seats contours
3. Tuck the cover through the crease of your seat and secure it on the backside (Most seat covers use Velcro or snaps to stay in place)
4. Once the back piece is secured, slide the cover's bottom piece over your seat's lower cushion (Make sure that the covers seams line up with the seat's contours)
5. Tuck the seat cover through the crease of your seat and run the tie-down straps from the front of the cover to the back. Connect the straps to the back and tighten then for a snug fit
6. Slide the headrest covers into place and put your headrests back onto the seat

Bench Seats

1. Remove your headrests
2. Place the seat cover's back piece around the bench seats back and pull it tight, making sure that the covers seams line up with your seat contours
3. Tuck the seat cover through the crease of your seat and secure it on the backside with the Velcro or straps
4. Secure the Velcro seams around the outline of your seat, pulling as tight as you can
5. Once the back piece is in place, slide the cover's bottom piece over your seat's lower cushion
6. Tuck the seat cover through the crease of your seat and run the tie-down straps from the front of the cover to the back. Connect the straps to the back and tighten then for a snug fit
7. Slide on the headrest covers and insert your headrests back onto the seat

Now that you've seen just how easy it is to install seat covers, you can start to narrow down your choices if you haven't bought them already.  Check out the great selection of covers here at SharpTruck.com!